NEMA 23 (size 60mm) Vexta PV267-02BA, 6-wire stepper motor with 1.8deg resolution and holding torque of 310 oz-in (bipolar-series) and 240 oz-in (unipolar). The PV series features enlarged rotor and magnets, providing significant increase in torque, which on average is 1.5 times higher than a standard motor torque. Due to increased size of the rotor the frame is slightly larger than typical NEMA 23 motor, reaching 60mm (or 2.36 inch). However, it still fits perfectly in our NEMA 23 mounting bracket (see MBPR-23RA) as the mounting holes match the standard pattern and diameter. Very low inductance makes this motor a perfect choice for higher speed operation. Double shaft with flats on both sides for easy mounting of the flex coupler, damper or encoder. We sell this motor with preassembled Damper on back side. The retail value of the motor (without Damper) is $103. The attached Damper D6CL-6-3F provides additional 0.77 oz-in2 of inertia for smooth operation. This damper itself cost $42. If not needed, it can be removed by unscrewing small set screw. You can attach encoder in place of a damper. For detailed specification click here: PV267-02BA Motor comes with 10 inch wires terminated with 4-pin connector. NOTE: as shown on the pictures, the wires are terminated with 4-pin connector. However, all 6 wires are available for other type of connections, like unipolar. Just cut off the connector and heat shrinked tube to get all 6 wires). We have very limited quantities of these motor-damper sets left so please hurry up!
|Holding Torque||201 - up oz-in ( 141 - up Ncm )|