Brand NEW 5-phase driver from Oriental Motor. The UDK5107NW2 is a high quality driver for demanding industrial applications. Solid aluminum base and plastic protective cover allows for both horizontal and vertical mounting. Does not require additional heat sink.
The Run current may be adjusted from 0.19 to 0.75A/phase. The Standstill (Idle) current may be adjusted from 6 to 50% of the Run current.
The 2P/1P Pulse Input Mode switch, a very unique feature, allows to use almost any type of controller.
If the switch is in 2P mode, the motor rotation is controlled by CW and CCW pulse signals.
If the switch is in 1P mode, the motor is controlled by Step and Direction signals.
Another important feature is the Step Angle selection allowing for Full step operation at 0.72deg/step (500 steps/revolution) or Half step operation at 0.36deg/step (1000 steps/revolution).
The driver and motor are protected with Automatic Current Off Function. If internal temperature rises above 80C, the overheat signal will be output and the current to the motor will be cut off preventing both motor and driver from heat damage.
All inputs and outputs are opto-isolated for extra protection.
Comes with preassembled control cable (connector on driver side).

Recommended Motors:
- PK543AW, PK543BW
- PK544AW, PK544BW
- PK545AW, PK545BW
This driver will work with any other 5-phase motor with current from 0.19 to 0.75A/phase.

Does not require any additional power supply. Can be connected directly to the 110-115VAC power line.

More details you can find in Operating Manual for UDK5107

This is rare opportunity to buy a brand new driver for fraction of the cost. Our loss is your gain!

NOTE for inexperienced users - this is a 5-phase driver. Will NOT work with any 2-phase motor!

We expect this product back in stock on August 9th.